What is the Best Mold Killer?

mold killer, mold getting rid of, home mold test

We’re often asked what the best mold killer is. We wish there was one simple answer to that question. The fact is there are thousands of kinds of mold. The best mold killer for any given situation depends on what type of mold, how extensive the problem is and what types of surfaces are affected.

Determining the Type of Mold

To the untrained eye, many types of mold look alike, even when you are studying a detailed picture of mold in your home!  Even trained professionals have difficulty telling mold spores or appearances apart without lab analysis.

Until you have mold tested, treat it as if it is dangerous. Some kinds of mold can cause serious health problems. Always use protective equipment such as gloves and a protective face mask when removing mold. There is such a thing as a home mold test – you can buy a standard kit for just under $50. from the Home Depot and get an analysis completed in about 48-72 hours.

Determining the Best Mold Killer to Use

If you get a home mold test done – map the type of mold killer cleaning substance to the type of mold that you have in your home. If the mold problem is significant; i.e. over 100 square feet (10 by 10 foot space) then your better off calling a professional. If it’s a much smaller are most home remedies will take care of the mold problem:

  • Bleach and water. Used on a wide variety of surfaces for most types of mold and mildew.
  • Lemon juice, salt and soapy water. Often used for fabrics, especially those which are sensitive to bleach.
  • Bar soap and hot water. Sometimes used in place of commercial mold killer in shower stalls and other nonporous surfaces.
  • Bleach, dish soap and water. This solution is commonly used for drywall.
  • Dish soap, water, and ammonia (be careful not to use in same area as bleach solutions). Another solution often used for fabrics.

Basic Directions for Cleaning Mold

First, identify the area where you have mold and ventilate (open windows or use a fan) where you are cleaning.

Second, put on gloves and/or goggles and mix your bleach solution – this should be one cup of bleach per gallon of water. And, you should have one gallon of water available for rinsing.

Third, clean the moldy area and let your solution and/or the items you are cleaning sit for 10-15 minutes (soaking in the solution); after 10-15 minutes has passed rinse the area with clean water.

Fourth, make sure you dry all surfaces thoroughly or products that you have cleaned. You may need to use a fan in some cases to put a volume of “healthy” air on the infected area. Mold grows in areas that are protected from sunlight and fresh air – introducing sunlight and ventilation are always good things to do as well.

Fifth, be prepared to repeat this process 2-3 times until all signs of mold are gone. If you can’t clean up an infected area after this number of treatments you may have to throw away the items and/or replace the surface area you are cleaning or rebuild in some way.

Getting Rid of Mold Not Challenging in Most Cases

Getting rid of mold is not challenging if you aren’t dealing with a huge amount and you are prepared to clean the infected area a number of times. If the mold persists, be prepared to throw away the items that are infected and/or rebuild or resurface the area. If the mold symptoms reoccur you may have a more serious problem that requires a professional mold remediation specialist.

Incoming search terms:

  • best mold killer
  • mold killer home depot
  • best black mold killer
  • black mold killer home depot
  • Best Mold and Mildew Killer
  • mold killer
  • what is the best mold killer
  • prossional mold killer
  • Best Mold Killer Product
  • mold killers

Click here to submit your review.


Submit your review
* Required Field

Leave a Reply

You must be logged in to post a comment.

stendra avanafil